Adder CATx Dual Computer Access Module with Audio and Serial Support For Use With AdderView CATx KVM Switches and/or Adder Extender Receivers (AdderLink X100 or X200).
CATx Dual CAM - Share a single computer between two sets of peripheral devices
The CATx Dual Computer Access Modules (CAMs) are highly compact devices that allow you to share a single computer between two sets of peripheral devices. In simple terms the CAM can be viewed as a combined video splitter and peripheral hub. This is useful for mixing local and remote stations or mixing KVM with extension or signage systems.
The module connects to the video, USB, audio and RS232 ports of your computer and then connects via CAT 5, 5e or 6 cabling to the AdderView CATx KVM switches and/or Adder extender receivers (either AdderLink X100 or X200), each of which can be located up to 300 meters from the module. Your video display, keyboard, mice and speakers are linked to the remote devices.
Resolutions and cable lengths
The maximum resolutions achievable are:
1920 x 1200 @ 60Hz at 100m.
1600 x 1200 @ 60Hz at 200m.
1280 x 1024 @ 60Hz at 300m.
Two channel CD quality audio is supported.
Absolute mouse mode support
Supports absolute mouse mode when used in conjunction with supporting equipment.
EDID display information
The module contains a default set of EDID information that supports display resolutions up to 1920 x 1200 @ 60Hz. In addition, the module will check during power up whether alternative EDID information is available from the KVM switch or extender that is connected to port A. If required, you can also harvest and store new EDID information from your display (Read and Store).
The CATx Dual CAM uses a USB port to derive its power from the host computer, dispensing with the need for a separate power supply and thus simplifying installation.
Therefore the USB cable must always be connected to a USB port on the computer that is capable of providing up to 300m.
Control of the host computer is arbitrated by the module on a first come, first served basis. At the moment that a key is pressed or a mouse is moved by a user, the keyboard and mouse of the other user are temporarily locked-out (the video images remain). The keyboard indicators of the locked-out user then begin to flash to confirm their status. After two seconds of inactivity from the user currently in control, the module returns to its idle condition and re-instates the keyboard indicators of the locked-out user.
RS232 for disabling/re-enabling receiver connections
When required, a user of one remote link can disable (and re-enable) the other remote link using serial port commands.